Lumenier tinyFISH F3 16x16mm Flight Controller w/ Built-in 8CH SBUS FrSky Receiver

You are currently viewing Lumenier tinyFISH F3 16x16mm Flight Controller w/ Built-in 8CH SBUS FrSky Receiver
  • Post author:
  • Reading time:2 mins read

The Lumenier tinyFISH F3 Flight Controller brings incredible power and performance to the micro brushless world. It uses a powerful F3 processor along with top of the line hardware. Now you can get all the performance from an F3 based flight controller in a truly micro size! This flight controller uses 16x16mm mounting holes and a low profile design allowing for smaller airframe designs than ever before. The tinyFISH comes with BetaFlight pre-installed.

The tinyFISH F3 Flight Controller has a built 8CH SBUS FrSky compatible receiver, making setup a breeze. This flight controller has been designed by and named after our friends at under an open source license.

Software/Hardware Features

  • 1-3S Direct Lipo input support (3-12v) (LiPo power is required for PC connectivity!)
  • 16x16mm hole to hole spacing (20x20mm outer dimension)
  • Integrated FrSky compatible SBUS receiver (basically an integrated uSKY rx)
  • STM32F3 CPU
  • MPU-6000 SPI gyro
  • Supports DSHOT
  • Integrated Blackbox dataflash
  • Integrated voltage- and current-sensor
  • Buzzer output
  • RGB led output
  • Open hardware


  • CPU: STM32F3
  • SPI: ICM-20608-G Accelerometers and Gyroscope
  • Mounting Hole: 16x16mm, M2
  • Can support current, voltage monitoring
  • 2.4G Receiver 
  • Channel: 8CH
  • SUBS Output
  • Control Range: 200m
  • Compatible with Frsky X9D Plus Transmitter


  • 1x Lumenier tinyFISH F3 Flight Controller
  • 1x Set of nylon spacers, screws, nuts

Farees Ahmed

The aim of this blog is to serve as a quick reference guide for the Curious. Appreciate your feedback and comments !